Running the map examples

After successfully installing the software, you can run the map examples included in the installation to test the installation to ensure the Command Server is functioning properly.

About this task

To run the map example

Procedure

  1. Run the setup script.
  2. Execute the map:
    • Go to install_dir/examples/general/map/sinkmap
    • From the command line, type:
      dtx sinkmap

      The Command Server updates the screen while the map executes. If the map ran successfully, the following message is displayed:

      Map completed successfully

      If the map does not complete successfully, see Using a Command Server for troubleshooting information.